I mistakenly break the tool and it will error in 1.6.3 It fixed some kind of unknown crash in rare case. If you scaled your object in Object Mode, you need to apply the scale transform before using Face Cutter, otherwise it may cause problems. You can press T key to cut-through the mesh and then break apart into solid pieces.Īlso you can press Shift + T to limit the cut+break only on linked geometries. When you select a base edge, you need to choose one face for alignment (just move the cursor to near it). When you selected faces with different normals (non-planar), you can still cut and the cut will be "projected" onto the faces. You can press Number keys 1-9 to set the number of snapping points directly. This is a powerful way to create diagonal cutting lines between multiple edges. In this mode all snapping points will show up, you can just click the points to create cutting line easily. You can press E key anytime to switch into Easy Edit mode. Pressing D key again will set it to -45 degree. You can set the line rotation to 45 degree by just pressing D key. If will copy all cutting lines as mirrored. You can easily copy all the cutting lines to another side by pressing S key. (below is the screenshot of tool hint text) You can press Ctrl + Z key to undo a cutting-line (remove last added line). After all the lines set, press Q or R key to execute. The tool allow you to create some cutting-lines on one side, then Press Esc key, to return to "Edge selection" state, then select another edge for the base, and then create new cutting-lines again. You can create multiple cutting lines based on different edge. #FACE PHOTO BLENDER FULL#In Full Width Mode, the tool will try to use the full side (all co-linear edges). You can press W key to toggle Full Width Mode. When you work on multiple faces, sometimes you want to use the full side instead of small edge segment. To revert the line to original angle (perpendicular), move your cursor to your original selected edge then press A key. Just move your mouse cursor near an edge, then press A key. You can align the line easily by pressing A key. Z key or X key : Rotate the line by 5 degree.Ĭ key or V key : Rotate the line by 1 degree. You can quickly fill all the snapping points with lines by F key. You can also press Shift + R key to limit the cut to linked faces only. In order to cut through the mesh, press R key to execute the cutting. Note : You can hold Shift key anytime to turn off the snapping. (or you may use square bracket keys (the keys)).Īfter setting the cutting points, you can press Q key to execute cutting. You can increase the number of snapping points by Ctrl + mouse wheel scrolling. Select an edge (highlighted by yellow), then you can set "cutting lines" on the snapping point, or anywhere. Then right-click to open Context Menu, choose "Face Cutter" at the bottom of the menu. Also, it is similar to Ctrl R in blender, but this tool works on ngons too.Įdit mode > Select a face or multiple faces It provides better functionalities comparing to original blender's K knife tool. It is a very convenient tool for general modeling task. Set number of divisions (snapping points), then cut by lines.Ībility to cut through the whole mesh (using blender's Knife projection API) It allows you to cut perpendicular lines (or rotated) on selected face, by easily defined snapping points. Face Cutter is a handy modeling tool designed for cutting ngon face easily.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |